Rear Seat Belt Guide In Rear Shelf, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Install the seat belt guide -1- with the edge turned approximately 90° over the cut-out in the rear shelf as shown.
-- Insert the seat belt guide into the corner of the cut-out while turning it in the cut-out at the same time -arrow-.
-- Push the seat belt guide downward until the tabs engage in the rear shelf.
Further installation is performed in reverse order of the removal.