Glove Compartment Lid, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove the glove compartment lid damping element. Refer to GLOVE COMPARTMENT LID DAMPING ELEMENT, REMOVING AND INSTALLING .

-- Place the glove compartment on a soft surface.

-- Open the glove compartment lid and drill a hole in the glove compartment lid from the inside -arrow- at the height of the hinge pin -1- using a 10 mm drill bit, as shown.

-- Repeat the procedure on the opposite side.

-- Using the drift punch, drive the hinge pin -2- out through the hole -arrow A- in the glove compartment lid in the -direction of arrow B-.

Courtesy of AUDI OF AMERICA, LLC

-- Repeat the procedure on the opposite hinge pin.

-- Remove the glove compartment lid -1- from the glove compartment.