Overview - Luggage Compartment Roll Cover

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Luggage Compartment Roll Cover

Courtesy of AUDI OF AMERICA, LLC

Luggage Compartment Cover Motor 1 -V473-
- Equipped on some models
- Component location
  - All except g-tron: behind the lock carrier trim panel
  - g-tron: behind the left luggage compartment side trim panel
- Available only with OVERVIEW - LUGGAGE COMPARTMENT ROLL COVER => List Item:Roll Cover Guide Rail
- Removing and installing. Refer to LUGGAGE COMPARTMENT COVER MOTOR, REMOVING AND INSTALLING .
Rivet
Locking Pin
- Not available separately from the repair kit. Refer to the Parts Information.
- Riveted with roll cover
Roll Cover Catch
- Clipped into the guide rails
- Removing and installing. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
Clip
- Insert into the roll cover guide rail
- Remove any remaining clips in the D-pillar mounting points using the Omega Clip Tool:T40280 . To install, insert into the roll cover guide rail.
- Replace damaged or deformed clips
Roll Cover Guide Rail
- Available only with OVERVIEW - LUGGAGE COMPARTMENT ROLL COVER => List Item:Luggage Compartment Cover Motor 1 -V473-
- Removing and installing. Refer to LUGGAGE COMPARTMENT COVER MOTOR, REMOVING AND INSTALLING .
Bolt
- 4.5 Nm
Bolt
- 2.5 Nm
Luggage Compartment Roll Cover
Frame
- For luggage compartment roll cover handle
- Not available separately from the repair kit. Refer to the Parts Information.
- Replacing. Refer to LUGGAGE COMPARTMENT ROLL COVER HANDLE, REMOVING AND INSTALLING .
Luggage Compartment Roll Cover Handle
- Not available separately from the repair kit. Refer to the Parts Information.
- Replacing. Refer to LUGGAGE COMPARTMENT ROLL COVER HANDLE, REMOVING AND INSTALLING .
Bolt
- Quantity: 2
- thread cutting
- Position the bolt by hand and tighten it until it finds the old threads. Then tighten the bolt to the specification.
- 0.35 Nm
Release Cable Bracket
Release Cable Adjuster
Nut
- Quantity: 3
- 2.5 Nm