Rear Center Console Vent, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Carefully guide the Hook Tool:T40207 between the slats and engage behind the vent -1-.
-- Alternating between both sides, carefully remove the vent from the installation opening -arrow-.
-- Disconnect the connector.
-- If the hook cannot be engaged, remove the center console rear trim. Refer to CENTER CONSOLE REAR TRIM, REMOVING AND INSTALLING .
-- Release the vent -1- at the clips -arrows- and press it out of the trim at the same time.