Fuel Pump Control Module -J538-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Observe the safety instructions. Refer to SAFETY PRECAUTIONS .

-- Follow the guidelines for clean working conditions. Refer to GUIDELINES FOR CLEAN WORKING CONDITIONS .

Cabriolet:

-- Remove the right rear side trim panel. Refer to COMPONENT LOCATION OVERVIEW - VEHICLE INTERIOR TRIM PANELS .

-- If installed, remove the Right Rear Subwoofer -R240-. Refer to COMPONENT LOCATION OVERVIEW - SOUND SYSTEM .

All:

-- Remove the bench seat. Refer to BENCH SEAT/SINGLE SEAT, REMOVING AND INSTALLING .

-- Release the catches -arrows- using a screwdriver and remove the Fuel Pump Control Module -J538- -item 1- from the bracket.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuel pump control module from under the sill panel/side trim panel.

-- Release the connector safety catch and disconnect the connector -2- for the Fuel Pump Control Module -J538-.