OVERVIEW - EVAP SYSTEM, VEHICLES WITH Fuel Tank Pressure Sensor -G400-
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The overview only applies to TFSI vehicles.
- Nut
- 20 Nm
- Bolt
- Tightening specification. Refer to OVERVIEW - MUFFLER .
- Bolt
- Quantity: 2
- 8 Nm
- Nut
- 20 Nm
- Bracket
- EVAP Canister
- Component location: right rear
- Removing and installing. Refer to EVAP CANISTER, REMOVING AND INSTALLING, VEHICLES WITH Fuel Tank Pressure Sensor -G400- .
- Bolt
- Quantity: 3
- 1.5 Nm
- Bleeder Line
- From the fuel tank
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Bleeder Line
- To the EVAP Canister Purge Regulator Valve 1 -N80-
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Clipped to the underbody
- Nut
- 5 Nm
- Bracket
- Vent Line
- Vents out to the right rear under the wheel housing liner
- Connector Couplings, Disconnecting and Connecting. Refer to CONNECTOR COUPLINGS, DISCONNECTING .
- Fuel Tank Pressure Sensor -G400-
- Removing and installing. Refer to Fuel Tank Pressure Sensor -G400-, REMOVING AND INSTALLING .
- Seal
- Bracket
- Nut
- 20 Nm
- Bolt
- Quantity: 2
- 8 Nm
- Fuel Tank Leak Detection Control Module -J909-
- Component location: right front on the fuel tank
- Removing and installing. Refer to Fuel Tank Leak Detection Control Module -J909-, REMOVING AND INSTALLING .
- Nut
- Quantity: 2
- 2 Nm
- Heat Shield
- Bolt
- Quantity: 3
- 8 Nm