Component Location Overview - Seat Occupant Detection System
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
- Wiring Harness
- Seat position sensor/control module/seat belt switch
- Available only with -Item : Seat Position Sensor
- Clip into the seat pan
- Black connector, connector station in the vehicle floor under the seat
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Wiring Harness
- For the seat heating element with seat occupant detection system
- Available only with -Item : Right Front Seat Heating Element -Z46-
- Clip into the seat pan
- Connector station in the vehicle floor under the seat.
- Removing and Installing. Refer to SEAT OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Seat Occupant Detection System Control Module -J706-
- Removing and Installing. Refer to SEAT OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Bolt
- 1.5 Nm
- Control Module Bracket
- Clipped in the seat pan and secured using the expanding pins
- Right Front Seat Heating Element -Z46-
- Allocation. Refer to the Electronic Parts Information (ETKA).
- Only available together with the cushion and -Item : Wiring Harness
- The seat occupant detection system is bonded on the cushion
- Removing and Installing. Refer to SEAT OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
- Nut
- 1.5 Nm
- Seat Position Sensor
- Driver Seat Position Sensor -G553-
- Front Passenger Seat Position Sensor -G554-
- Available only with -Item : Wiring Harness
- Shown on the front passenger side
- Check using the.
- Removing and Installing. Refer to SEAT POSITION SENSOR, REMOVING AND INSTALLING .
- Bolt
- Tightening specification -Item : Bolt.