Connector On Airbag, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
CAUTION:
Pyrotechnical components can deploy unintentionally.
Risk of injury.
- Discharge the static electricity: quickly touch the door striker.
-- Connect the connector -1- to the airbag igniter in the direction of -arrow A-.
-- Press in the connector lock -2- in the direction of -arrow B-. While doing this, the connector is pushed into the airbag igniter all the way and locks into place.
- If the instrument cluster indicates a fault in the airbag system after assembly, the DTC memory must be checked, erased, and then checked again. Refer to appropriate service information.