Charge Air Pressure Sensor -G31-, REMOVING AND INSTALLING, BOLTED VERSIONS: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

All except Audi A8/Q7/Q8:

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the screw-type clamp -2-, remove the air duct pipe from the Throttle Valve Control Module -GX3- and slightly push it to the left side.

-- Seal off any open lines and connections with plugs that are thoroughly cleaned from the Engine Bung Set:VAS 6122 .

All except Audi Q7/Q8:

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

-- Remove the bolt -2- and remove the Charge Air Pressure Sensor -G31- from the air duct pipe (different installation positions).

Audi Q7/Q8:

-- Remove the front noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Remove the bolts -2- and the Charge Air Pressure Sensor -G31- (Shown with the bumper cover removed).

Fig 1: Charge Air Pressure Sensor -G31- Component Location

Courtesy of AUDI OF AMERICA, LLC