INNER FRONT COOLANT PIPE ON Electric Drive Power and Control Electronics -JX1-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Secure all hose connections with hose clamps that match the ones used in series production. Refer to the Parts Information.
Used coolant cannot be used again.

-- Connect the coolant hose to the connector coupling. Refer to Figure.

-- Fill the cooling system. Refer to COOLING SYSTEM, FILLING, HIGH-VOLTAGE SYSTEM COOLING CIRCUIT .