Wheel Bearing Unit, Removing And Installing, Fwd: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace the bolt and dust cap after removal.
-- Apply the front seal -1-.
-- Lightly lubricate the metal washer -2- and the axle stub -arrow- with grease. Refer to Parts Information
-- Carefully slide the wheel bearing unit on the axle stub and do not tilt while doing so.
-- Install the brake rotor. Refer to BRAKE ROTOR, REMOVING AND INSTALLING .
Install in reverse order of removal. Note the following:
CAUTION:
There is a risk of premature wear on the wheel bearing.
- Use the tools pictured to avoid any moisture entering through a damaged dust cap.
-- Drive in the new dust cap all the way using the Camshaft Installer Kit - Sleeve :3241/4 -1-.