Spring, Removing And Installing, RS Competition: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- Pay attention to the installation position of the coil spring. Refer to Figure.
-- Bring the coil spring and the spring plate into the installation position. Refer to Figure.
-- Position the Engine and Gearbox Jack:VAS 6931 with the transmission support to the lower transverse link and lift it until the eccentric screw can be inserted.
-- Adjust the adjusting nut -1- at the spring plate -2- to the dimension -a-.
- Dimension -a- = maximum 10 mm
- Overview table for when an axle alignment is needed. Refer to NEED FOR AXLE ALIGNMENT, EVALUATING .