Upper Transverse Link
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Wheel Bearing Housing
- Bolt
- 70 Nm + 180°
- Replace after removing
- Front Upper Transverse Link
- Removing and installing. Refer to FRONT UPPER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
- Eccentric Screw
- Subframe
- Bolt
- 40 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Nut
- Replace after removing
- Nut
- Replace after removing
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Rear Upper Transverse Link
- Removing and installing. Refer to REAR UPPER TRANSVERSE LINK, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Nut
- 90 Nm
- Replace after removing
- Loosen and tighten using an 18 mm or 21 mm twelve-point socket
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
- Eccentric Washer
- Tie Rod
- Removing and installing. Refer to TIE ROD, REMOVING AND INSTALLING .
- Installation position. Refer to Fig 2.
- Bolt
- 70 Nm + 180°
- Replace after removing
- Tighten in the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
Transverse Link and Tie Rod Installation Position
- The ball side -2- on the transverse link or tie rod must engage in the wheel bearing housing -1-.