Seat Depth Adjuster, Removing And Installing, Q3: Removing

WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the trim from the seat depth adjuster. Refer to SEAT DEPTH ADJUSTER TRIM, REMOVING AND INSTALLING .

-- Disconnect the connector -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the hooks -arrows-, and fold the retaining plate with cushion and cover toward the rear.

-- Disengage the contour wire on the left and right side from the hooks -A arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Using the Hook Tool: T40207 , disengage the cover clamping strip from the hooks -B arrows-.

-- Move the seat depth adjuster back again, so that the bolt heads -arrows- are accessible.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts by counterholding the nuts at the bottom.

-- Unclip the seat depth adjuster -1- at the tabs -A arrows- and remove upward from the seat pan.

Courtesy of AUDI OF AMERICA, LLC

-- Disengage the seat depth adjuster at the tabs -B arrows- from the seat pan.