Lumbar Support, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Remove the backrest seat cover and cushion. Refer to BACKREST COVER AND CUSHION, REMOVING AND INSTALLING, A3 SPORT SEAT .
-- For reinstallation, mark pneumatic lines at the separating point with a waterproof permanent marker.
-- Disconnect the pneumatic line -1- to the compressor for the multi-contour seat at the marking -arrow-. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING .
-- Disconnect the connector -arrow- from the control module.
Fig 1: Front Passenger Multi-Contour Seat Control Module -J872- /Driver Multi-Contour Seat Control Module -J873-
-- Remove the screw -arrow A-.
-- Pivot the lower lumbar support toward the front from the backrest frame and disengage and remove from the top of the lumbar support -B arrows-.