Driver Multi-Contour Seat Compressor -V439- /Front Passenger Multi-Contour Seat Compressor -V440-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Audi S3, 2022 Audi RS 3, 2022 Audi A3 Quattro, and 2022 Audi A3. However, it is still accessible from the selected car via links, so may be relevant.
-- Unscrew the front seat and tip to the rear with the wires attached. Refer to FRONT SEAT, REMOVING AND INSTALLING .
-- Equipped on some models: remove the fire extinguisher bracket. Refer to FIRE EXTINGUISHER MOUNT, REMOVING AND INSTALLING .
-- Disconnect the pneumatic line -2- from the pump -1- by pressing the release ring in direction of -arrows-.
-- Disengage the rubber mounting -1, 2 and 3- from the bracket in direction of -arrows- using pliers.
-- Remove the pneumatic system pump with the bracket -4-.
-- Disconnect the connector for the wire -5- and free up to do so release the connector safety catch.
-- Release the catch in direction of -arrow- and slide the pneumatic system pump -1- down to the side away from the bracket -2-.