Stabilizer Bar, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Before starting the procedure, determine the curb weight position. Refer to WHEEL BEARING IN CURB WEIGHT POSITION, LIFTING VEHICLES WITH COIL SPRING .
-- Lower the subframe crossbrace and do not press off the guide link joint pin while doing this. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
-- Remove the left and right nuts -arrows- and -3-.
-- Remove the left and right clamp -1- and bolt -4-.
-- Remove the stabilizer bar -2-.