Lane Change Assistance Control Module -J769- /Lane Change Assistance Control Module 2 -J770-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bumper cover. Refer to BUMPER COVER TRIM, REMOVING AND INSTALLING .
-- Release the catch -3- and tilt the control module -2- out -arrow-.
-- Disengage and remove the control module from the lower mount -4-.
-- Disconnect the connector -1-.