Rear Lid Tail Lamps, Removing And Installing, AVANT: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Check the self-adhesive seal -2- on the tail lamp -1- for damage.
- A damaged or incorrectly attached seal must be replaced.
TIP:
Water can get into the vehicle interior due to a damaged or incorrectly applied seal.
-- Insert the tail lamp and tighten the nuts.
-- Place the cover -2- on the tail lamp -1- -arrows- and then press it on.