Front Parallel Parking Sensor, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing Front Sensor

Courtesy of AUDI OF AMERICA, LLC

-- Loosen the wheel housing liner in the front area and push it aside. Refer to FRONT WHEEL HOUSING LINER, REMOVING AND INSTALLING .

-- Press both retainers to the side -arrows- and at the same time, push the sensor -1- through from the outside toward the inside.

-- Disconnect the connector -2- by sliding the retainer -3- toward the rear and pressing the release down.