Alcohol Interlock System, Removal
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Pay attention to the manufacturer instructions.
Removing
-- Connect the Vehicle Diagnostic Tester.
-- Select "flash".
-- Select "Enter SVM code".
-- Perform the software update with SVM code -46A610-.
-- Switch the ignition off.
-- Remove the 20 A fuse in Fuse Panel 3 - ST3- from location 5 in the left side of the luggage compartment.
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .
-- Remove the alcohol interlock system control module and handheld from the glove compartment.
-- Remove the wires from the glove compartment, secure them to the bulkhead and insulate them.
-- Remove the grommet, close holes in the glove compartment with fitting plugs.
-- Install the glove compartment.