Metal Valve Body, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Securing Against Turning With Counter Hold

Courtesy of AUDI OF AMERICA, LLC

-- Place the metal valve with rubber seal through rim from inside.

-- Position the beveled washer and union nut from outside and tighten.

-- Secure against turning with counterholder -1- (for example, a 2 mm drill bit).

-- Push the tire pressure monitoring sensor -1- into the bed and tighten.

Fig 2: Pressing Wheel Electronics Into Bed

Courtesy of AUDI OF AMERICA, LLC