Axle Alignment Test Requirements
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- Follow the general information regarding vehicle alignment. Refer to AXLE ALIGNMENT INFORMATION .
- Before driving the vehicle onto the alignment rack, make sure there is enough space between the vehicle and the setting device. Distance between the setting device and the vehicle: 120 cm ± 2.5 cm.
- If there is not enough space, drive the vehicle backward on the alignment rack to be able to use the space.
- Vehicle must be cool.
- Check suspension, steering and steering linkage for excessive play and damage, repair if necessary.
- Tread depth difference may be no more than 2 mm on an axle.
- Prescribed tire pressure
- Make sure that the sliding plates and turn tables are not touching the end stop when checking the wheel alignment.
- The measurement sensor must be properly adjusted and attached to the vehicle; observe device manufacturer's operating instructions.
- The alignment rack and wheel alignment computer can deviate from their original calibration over time; therefore, they should be calibrated at least once a year during maintenance.
- Handle highly sensitive units with care.
- If necessary, contact the manufacturer for instruction on the proper use of the equipment.