Sunroof Shade Motor -V260-, REMOVING AND INSTALLING, A4 AVANT: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the C-pillar trim panel on the driver side. Refer to C-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the roof end strip. Refer to ROOF END STRIP, REMOVING AND INSTALLING .
-- Remove the D-pillar trim panels. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Open the sun shade completely.
-- To avoid dirtying the headliner, clean the Removal Wedge:T40233 .
-- Push the Removal Wedge:T40233 between the frame -1- for the sliding sunroof and the headliner.
-- Using the Removal Wedge:T40233 , loosen the headliner all the way around the frame for the sliding sunroof -arrows-.
-- Disconnect the connector -1-.
-- Remove the bolts -arrows- and remove the Sunroof Shade Motor -V260-.