Glass Panel, Removing And Installing, Rear, A4 AVANT And Market-Specific Version: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Remove any locking fluid residue from the threaded hole using a thread tap.
-- Install the rear glass panel bolts, but do not tighten.
-- Adjust the rear glass panel (refer to GLASS PANEL, ADJUSTING ), then tighten the bolts.
-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .