Glass Panel, Removing And Installing, A4 Sedan: Installing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove any locking fluid residue from the threaded hole using a thread tap.

-- Install the glass panel bolts but do not tighten them yet.

-- Adjust the glass panel (refer to GLASS PANEL, ADJUSTING, A4 SEDAN ) and then tighten the bolts.

Install in reverse order of removal. Note the following:

-- Perform an adaptation. Refer to Sunroof Motor -V1-, PROGRAMMING .