Mounting Bracket, Removing And Installing: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Equipped on some models: install the wiring harness -1- for the exterior door handle touch sensor/exterior door handle illumination on the mounting bracket -3- and on the door lock -2-. Pay attention to the wire routing -arrows-.
TIP:
If the wiring harness is not routed correctly, there may be noises when opening and closing the door window, because the door window grazes the wiring harness.
Tightening Specifications
- Refer to OVERVIEW - DOOR HANDLE AND DOOR LOCK