LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Hood, Lids) >> 55 Hood, Lids >> Rear Lid >> Gas-Filled Strut, Removing And Installing >> Removing

Gas-Filled Strut, Removing And Installing: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Support the rear lid or secure it from falling.

-- A4 Sedan: remove the right luggage compartment side trim panel. Refer to LUGGAGE COMPARTMENT SIDE TRIM PANEL, REMOVING AND INSTALLING .

-- Using a small screwdriver, lift the locking spring -1- slightly and remove the gas-filled strut -2- from the upper ball pin.

Fig 1: Lifting Locking Spring Using Small Screwdriver
GWWA55-10891Courtesy of AUDI OF AMERICA, LLC