Rear Lid Adjusting Buffer
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Loosen the rear lid lower trim panel near the adjusting buffer. Refer to REAR LID LOWER TRIM PANEL, REMOVING AND INSTALLING .
-- Turn the adjusting buffer -1- counter-clockwise -arrow- and remove it.
Install in the reverse order of removal while noting the following:
-- Check the seal -2- between the adjusting buffer and the rear lid for damage.
-- Adjust the adjusting buffer. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .