Body Adjusting Buffer
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
-- Turn the adjusting buffer -1- counter-clockwise -arrow- to remove.
-- Remove the adjusting buffer locking mechanism -2- from the threaded pin.
Install in the reverse order of removal while noting the following:
TIP:
To secure the adjusting buffer, the Pop Rivet Screw:WHT 005 180 must be inserted using the Pop Rivet Pliers:V.A.G 1765C and Pop Rivet Pliers - Supplement Pieces V.A.G 1765C/2. Refer to => 53 for detailed information. The >>infomedia search<< can be used here to search for the Pop Rivet Screw:WHT 005 180 in the respective information.
-- Adjust the adjusting buffer. Refer to HEIGHT, ADJUSTING USING ADJUSTING BUFFER .