Insulation, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- A4 and A5: first slide the insulation over the tabs on the rear edge and into the designated cut-outs on the inner panel -3-.
-- RS 4 and RS 5: push the insulation first over the tabs on the rear edge in the specified cut-out on the inner panel -3- and at the same time push the tabs of the heat shield in the specified cut-out on the insulation.
-- Insert the tabs at the front edge and sides.
-- The clips must engage audibly when pressing in.