Hinges, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Install the hinge according the marking made during removal.
-- Adjust the hinge. Refer to SIDE, LENGTH AND HEIGHT ADJUSTMENT AT HINGE .
If the fender flange is being replaced the following adjustment should be performed:
-- Position the hinge -1- as shown and install the bolts -2-.
- At the same time the threads -3- are located in the lower rear conner. This corresponds to the maximum distance of the hood.
-- Adjust the hinge. Refer to SIDE, LENGTH AND HEIGHT ADJUSTMENT AT HINGE .
- When opening and closing the hood or the front doors pay attention to the clearance.