Relay and Fuse Panel 2 -SR2-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Sedan: Loosen the luggage compartment side trim panel at the bottom by removing the tie downs. Refer to TIE DOWN, REMOVING AND INSTALLING .

-- Avant: Remove the luggage compartment floor support. Refer to OVERVIEW - LUGGAGE COMPARTMENT SIDE TRIM PANEL .

-- g-tron vehicles: Loosen the motor for the luggage compartment cover and move to the side. Refer to EXTRA EQUIPMENT .

-- Open the cover for the left luggage compartment side trim panel.

-- Release the retainer -1-.

-- Remove the bracket -2- for the control modules upward -arrow-.

-- If equipped, remove the rear lid buzzer. Refer to Rear Lid Warning Buzzer -H32-, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

-- Cut the cable tie -1-.

-- Remove the nut -2-.

-- Release the retainer -arrow-.

-- Lift the relay and fuse panel 2 -item 3- and remove toward the rear.

-- Open the clip in the -direction of the arrow- and remove the fuse panel -2- from the relay and fuse panel 2 -item 1-.

Fig 1: Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip and remove the auxiliary fuse panel -2-.

Fig 2: Auxiliary Fuse Panel

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips -arrows- and remove the relay -1- and the control modules from the relay panels.

-- Release the clips -arrows- and pull the relay panel -2- toward the rear out of the relay and fuse panel 2 -item 1-.

Fig 3: Identifying Relay Panel And Connector Station

Courtesy of AUDI OF AMERICA, LLC

-- Remove the relay and fuse panel 2.