Lifter, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Clean the adjusting screw threads -3- with a wire brush.
-- Remove any residual locking fluid from the threaded hole of the lifter -1- using a thread tap.
-- Check the stop washer -2- for damage and replace the lifter, if necessary.
- The stop washer must sit in the groove -arrow-.
-- Install the adjusting screw with locking fluid in the lifter.
-- Insert the lifter into the roof opening and secure it with the adjusting screw.