General Information - Name Badges And Emblems, Replacing

Special tools and workshop equipment required 

• Roller :T40400 

  Courtesy of AUDI OF AMERICA, LLC

• Cleaning Solution. Refer to the Parts Information.

• Loosened name badges and emblems must be replaced.
• The vehicle as well as the name badges and emblems must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.

-- Warm the adhesive areas to approximately 40 °C using a hot air blower.

• Neighboring components must be protected against temperature effects.

-- After successfully assembling, press on the emblems again with the roller.

• Resting time approximately 30 minutes at room temperature