Securing Strip For Side Sill Trim Panel, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

• The vehicle and the securing strip must be at room temperature.
• The adhesive surfaces must be free of dirt and grease.

-- Remove the adhesive residue from the body.

-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.

-- Apply Bonding Agent -item 1- on the painted adhesive surface -2- using the Applicator -item 3- and allow it to dry for 10 minutes.

Fig 1: Applying Bonding Agent To Adhesive Surface On Paint Side Using Applicator

Courtesy of AUDI OF AMERICA, LLC

• If the Bonding Agent :D 355 205 A2  dries longer than two hours, then it must be primed again.

-- Fold back the end of the protective film, or attach a pulling aid to the protective film.

-- Position the securing strip -1- using the centering pins -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the protective film on the pulling aids from the adhesive tape -3-.

-- Install the nuts -4-.

-- Press on the entire length of the securing strip.

• Resting time approximately 30 minutes at room temperature