Fender Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
- The vehicle and the trim must be at room temperature.
- The adhesive surfaces must be free of dirt and grease.
-- Remove the adhesive residue from the body.
-- Clean the painted side of the adhesive surface with Cleaning Solution and let it dry.
-- Remove the protective film -4- from the adhesive tape -2-.
-- Position the fender trim -3- under the pin on the fender -arrows-.
-- Push the fender trim on the fender and on the bracket -1- until it engages.
- Resting time approximately 30 minutes at room temperature