Condensers, Removing And Installing, S4/S5 TDI Gen III And RS Models: Removing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
- For all following procedures immediately seal all the open lines and connections with clean plugs from the Engine Bung Set :VAS6122 .
- Pay attention to the notes for the condenser. Refer to RADIATOR AND CONDENSER ASSEMBLY .
-- Remove the bumper cover bracket together with the impact member. Refer to OVERVIEW - LOCK CARRIER and BUMPER CARRIER, REMOVING AND INSTALLING .
-- Disconnect the refrigerant lines from the condenser. Refer to REFRIGERANT LINES, DISCONNECTING AND CONNECTING FROM CONDENSER .
S4/S5 TDI Gen III
-- Release the catches -arrow- and remove the air duct -1 and 3-.
RS Models
-- Release the catches in direction of -arrow- and remove the air duct -1 and 3-.
Continuation for All Vehicles
-- Disconnect the connector -1- for the High Pressure Sensor -G65-.
-- Remove the bolt -2-.
-- Release the left and right catches in direction of -arrows-, disengage and remove the condenser on the radiator.