Audi e-tron GT (F8_) from MY 2022
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
| Vehicle | Required Adapters for the Connections to A/C Compressor | Necessary Adapter for the Connections to the Dryer / for the Check Valves and Shut-Off Valves | Miscellaneous |
|---|---|---|---|
| Audi e-tron GT (F8_) from MY 2022 | -- Compressor manufacturer "Sanden" (block connections with radial sealing)
|
Dryer-- Dryer removed and replaced by Refrigerant Circuit Adapter :VAS 6338/76 . Refer to DESICCANT BAG/DRYER CARTRIDGE, REMOVING AND INSTALLING . | -- If necessary, connect the additional Quick-Release Coupling, Low Pressure to the filler hose of the Flushing Device using a fitting Adapter.
|
| Vehicles with heat pump-- Removed the check valve and replaced by the Adapter :VAS 6338/47-1 from the Refrigerant Circuit Adapter Set :VAS 6338/47 . Refer to the appropriate service information . | Open or close the Adapter :VAS 6338/47-1 corresponding to the section to be flushed. Refer to Refrigerant Circuit (vehicle-specific Service Information). | ||
| Vehicles without heat pump-- Install the Adapter :VAS 6338/47-1 from the Refrigerant Circuit Adapter Set :VAS 6338/47 into the refrigerant line dryer/condenser. | Open or close the Adapter :VAS 6338/47-1 corresponding to the section to be flushed. Refer to Refrigerant Circuit (vehicle-specific Service Information). |
NOTE:
On this vehicle, the refrigerant circuit is flushed in three or four steps (flushing cycles) depending on the vehicle equipment. Refer to Refrigerant Circuit (A/C System Refrigerant Circuit, Cleaning).
The design of the different flushing circuits is described in the vehicle-specific Service Information. Refer to Refrigerant Circuit (Cleaning the A/C system refrigerant circuit).
After flushing the dryer must be replaced. Refer to DESICCANT BAG/DRYER CARTRIDGE, REMOVING AND INSTALLING .
Depending on the cause for the flushing procedure, further components must be replaced after flushing. This is described in the vehicle-specific Service Information. Refer to Refrigerant Circuit (clean the refrigerant circuit of the A/C system).