Condensation Water Drain, Removing And Installing, A4 And A5: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch off the ignition.

-- Remove the glove compartment (for the right condensation water drain). Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove the driver side instrument panel cover (for the left condensation water drain). Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Carefully fold back the floor covering near the condensation water drain hose (left or right front at center tunnel) so that the condensation water drain is visible.

-- Check that both the condensation water drain hoses -B- are properly routed and for dirt. Correct, for example, if there is a constriction.

Courtesy of AUDI OF AMERICA, LLC

-- Cover the area under both openings -D- (for water drain hose opening -C-) with absorbent paper (so that any water present does not get under the carpet).

-- Remove both condensation water drain hoses -B-.