Coolant Shut-Off Valve -N82-, REMOVING AND INSTALLING: Installing
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following.
TIP
- Since only a small amount of coolant flowed out of the coolant circuit when removing the Coolant Shut-Off Valve -N82- as described above, the coolant flows into Coolant Shut-Off Valve -N82- after installing and removing the hose clamps (additionally opening the coolant expansion tank cap).
- The shut-off valve -A- is secured to the noise insulation via the rubber bushing -L- (with bearing bushings and washers) the nuts -G- and the bolts -F- on the bracket -K-.
-- Check the rubber bushing -L- is seated correctly in the bracket -K-.
-- Drain and fill the coolant circuit. Refer to the appropriate service information .
Tightening Specification
| Component | Tightening Specification |
|---|---|
| Coolant Shut-Off Valve -N82- on the bracket | 8 Nm |
| Bracket for the Coolant Shut-Off Valve -N82- on the plenum chamber | 8 Nm |