Right Flange Shaft, Removing And Installing: Installing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

Replace the circlip after removal.

-- Insert the circlip -1- with the Circlip Pliers:VAS 5503A .

-- Check the right flange shaft seal for damage and replace if necessary.

-- Fill the space between the sealing lip and the dust lip halfway with Sealing Grease.

-- Insert the right flange shaft.

-- Fill the transmission fluid and check the level. TRANSMISSION FLUID, DRAINING AND FILLING .

Tightening Specifications

Refer to OVERVIEW - DRIVE AXLE .
Refer to DRIVE AXLE HEAT SHIELD, REMOVING AND INSTALLING .