Dual Clutch, Removing And Installing: Installing: Notes

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Damage to the transmission housing as a result of remaining dirt.

There may be no liquid in the studholes for the bolts.

-- Clean the threads.

Courtesy of AUDI OF AMERICA, LLC

-- Clean the blind hole threads from oil.

-- Replace the input shaft seal in the clutch housing. Refer to INPUT SHAFT SEAL, REPLACING, CLUTCH HOUSING .

-- Check if the sleeves -1- and -2- are installed.

Courtesy of AUDI OF AMERICA, LLC

-- Coat the new seals -3, 4 and 5- with ATF and install.

-- Insert the seal -6-.

Pay attention that no dirt can fall into the transmission while cleaning.

-- Install the engaging bearing with the slave cylinder and tighten the bolts -arrows- evenly.

Courtesy of AUDI OF AMERICA, LLC

TIP:

Depending on the version the three bolts -arrows- may not be present.

Pay attention that the engaging bearing is installed correctly to the slave cylinder.

Courtesy of AUDI OF AMERICA, LLC
The bearings -arrow- are visible.

-- Install the Guide Pins - Gearbox:T40288 in the threaded hole approximately 120° offset.

Courtesy of AUDI OF AMERICA, LLC