Starter, Removing And Installing, Vehicles With 6-Cylinder TFSI Engine: Removing

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K0 .

-- Remove the front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

Equipment versions with Coolant Recirculation Pump -V50- :

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Release the retainer -arrow- and push the Coolant Recirculation Pump -V50- to the side.

Continuation for all:

-- Remove the generator. Refer to Generator -C-, REMOVING AND INSTALLING, VEHICLES WITH 3.0L TFSI ENGINE, 0K0 .

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -5- and nut -4-.

Fig 2: Identifying Starter Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter -item 1-, disconnect the connector -3- and free up the B+ wire -2-.