Starter, Removing And Installing, Vehicles With 6-Cylinder TDI Engine: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K0 .

6-Cylinder TDI Engine Gen I:

-- Remove the emissions control module. Refer to appropriate Repair Information .

6-Cylinder TDI Engine Gen II:

-- Loosen the rear coolant pipes on the transmission and push to the side. Refer to COOLANT PIPES, REMOVING AND INSTALLING .

Equipment versions with Coolant Recirculation Pump -V50- :

Courtesy of AUDI OF AMERICA, LLC

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Release the retainer -arrow- and push the Coolant Recirculation Pump -V50- to the side.

Continuation for all:

-- Remove the generator. Refer to GENERATOR, REMOVING AND INSTALLING .

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -5- and nut -4-.

Fig 2: Identifying Starter Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter -item 1-, disconnect the connector -3- and free up the B+ wire -2-.