LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2024 >> S3 Premium Plus >> Repair and Diagnosis >> External Pages >> Different car >> Section 187 (Battery, Starter, Generator, Cruise Control) >> 27 Battery, Starter, Generator, Cruise Control >> Starter >> Starter, Removing And Installing >> Starter, Removing And Installing, Vehicles With 6-Cylinder TDI Engine Gen III >> Removing

Starter, Removing And Installing, Vehicles With 6-Cylinder TDI Engine Gen III: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to Battery -A-, DISCONNECTING AND CONNECTING, 0K4 AND VH2 .

-- Remove the emissions control module. Refer to appropriate Repair Information .

-- Loosen the rear coolant pipes on the transmission and push to the side. Refer to COOLANT PIPES, REMOVING AND INSTALLING .

-- Remove the bolt -arrow-.

Fig 1: Identifying Plenum
GWWA27-10286Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter generator. Refer to Starter Generator -C29-, REMOVING AND INSTALLING, VEHICLES WITH 3.0L TDI ENGINE GEN III, 0K4 .

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -5- and nut -4-.

Fig 2: Identifying Starter Overview
GWWA27-10287Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter -item 1-, disconnect the connector -3- and free up the B+ wire -2-.