Starter, Removing And Installing, Vehicles With 4-Cylinder Engine: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the battery when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

Vehicle with Evo 4 engine with Particulate Filter:

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Free up the wires on the heat shield -1-.

Fig 1: Heat Shield For Vehicles With Particulate Filter

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -arrows- and bolt -2- and remove the heat shield.

Continuation for all:

-- Remove the right engine support. Refer to ENGINE SUPPORT, REMOVING AND INSTALLING .

-- Remove the bolt -arrow-.

Fig 2: Identifying Plenum

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolt -5- and nut -4-.

Fig 3: Identifying Starter Overview

Courtesy of AUDI OF AMERICA, LLC

-- Remove the starter -item 1-, disconnect the connector -3- and free up the B+ wire -2-.