Battery -A-, REMOVING AND INSTALLING, 0K2: Removing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

-- Switch the ignition off.

-- Remove the terminal 30 wire junction 3 and move it to the side with the wires still connected. Refer to Terminal 30 Wire Junction 3 -TV28-, REMOVING AND INSTALLING .

-- Remove the bolts -arrows-.

-- Remove the cover -1- to the side.

-- Free up the wiring harness -2 and 3-.

-- Remove the bolt -arrow-.

-- Remove the cover -1-.

-- Loosen the nut -8- several turns and remove the battery ground cable terminal clamp -7- from the battery negative terminal.

-- Open the cover -5- over the battery positive terminal.

-- Turn the nut -6- a few turns and remove the battery positive cable terminal -4- from the battery positive terminal.

-- Remove the bolt -2- on the battery bracket -1-.

-- Lift the battery -3- up and out of the battery tray.

The disposal regulations for batteries and sulfuric acid must be followed when disposing of batteries. Refer to Battery .