LEFT SEAL, REPLACING, 0D3 "quattro sport" AND 0BX "quattro sport": Installing

WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

Install the right shaft seal.

Fig 1: Identifying Flange Shaft Seal, Installation

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

-- Install the shaft seal all the way. Be careful not to bend it.

Installing the left shaft seal

Fig 2: Identifying T40221

Courtesy of AUDI OF AMERICA, LLC

-- Coat the outer circumference and the sealing lips on the shaft seal with ATF.

-- Install the shaft seal all the way. Be careful not to bend it.

-- Insert the flange shaft.

Tip:

If it is not possible to install the flange shaft all the way in by hand, then use a plastic mallet.

-- Tighten the new flange shaft bolt to the tightening specification ) OVERVIEW - FINAL DRIVE, DISASSEMBLING AND ASSEMBLING, 0D3 AND 0BX "quattro sport".

-- Install the rear final drive. Refer to FINAL DRIVE, REMOVING AND INSTALLING .

-- Check the ATF level in the rear final drive. Refer to ATF LEVEL, CHECKING .