TORQUE DISPLACEMENT, CHECKING, 0D3 "quattro sport" AND 0BX "quattro sport"
WARNING: This page is about a different car, the 2024 Audi A4 allroad. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Pay attention to the general repair information. Refer to REPAIR INFORMATION .
- Pay attention to the safety precautions. Refer to SAFETY PRECAUTIONS .
Procedure :
After the following work, the function 0032- Checking the torque displacement must be performed:
- Working on the rear final drive wiring
- Working on the valves: All-Wheel Drive Clutch Valve -N445- and All-Wheel Drive Clutch Valve 2 -N446-.
- Working on the hydraulic control unit
-- Lift the vehicle on a hoist just far enough until the wheels are no longer touching the floor.
-- Connect the Vehicle Diagnostic Tester and turn on the ignition.
-- Select the function 0032 - Torque Displacement, Checking in the vehicle diagnostic tester under Guided Functions in the directory 0032- Locking Electronics .
- Follow all the instructions given by the Vehicle Diagnostic Tester exactly.
Use the Vehicle Diagnostic Tester to check if the torque is stored for the correct side when the rear final drive is activated.